After replacing the new car brake pads, it needs to be run-in to increase the contact area between the brake pads and the brake disc, so that the braking effect can be better.

Automobile brake pads and brake discs are consumables. When we step on the brake pedal, the automobile brake pads and brake discs will gradually be consumed in friction. When the degree of wear reaches the limit, it needs to be Replacement treatment. After the new brake pads are replaced, the contact surface of the brake pads and the brake disc fails to reach effective contact, which affects the braking performance, and the so-called "braking" situation will occur. Therefore, the new brake pads need to be run-in to increase the contact area between the brake pads and the brake disc, so that the braking effect can be better. The following automobile brake pad manufacturers will take you to understand the method of brake pad running-in.

Brake pads also need to run in

The newly replaced brake pads will better fit the brake disc after running-in, so that its braking performance can be fully exerted. The commonly used methods are as follows: choose a place with good road conditions and few cars; accelerate to 60～80km/h, lightly step on the brake and brake with moderate force to reduce the speed to about 10-20km/h; release the brake to drive Allow the brake pads and disc temperature to cool down a few kilometers; repeat the above steps several times until you feel comfortable braking.

The above is the relevant knowledge of brake pad running-in brought to you by the brake pad manufacturer. Follow the official website of Qiwei Company, we will bring you more relevant knowledge!